1. Kirish
The KINGBOLEN EL-50448 is a specialized automotive tool designed to reset and relearn Tire Pressure Monitoring System (TPMS) sensors in various GM series vehicles. This tool is essential when replacing TPMS sensors, rotating tires, or performing other maintenance that requires the vehicle's TPMS module to recognize new sensor IDs. It operates by activating the TPMS sensor, allowing the vehicle's system to read and store the sensor's unique ID.
Figure 1: The KINGBOLEN EL-50448 TPMS Relearn Tool shown next to a car wheel, illustrating its function in activating tire pressure sensors.
2. Avtomobil mosligi
The EL-50448 tool is compatible with GM vehicles equipped with either 315 MHz or 433 MHz TPMS sensors. This includes a wide range of cars, trucks, and pickups from the GM series.
Figure 2: The EL-50448 tool indicating compatibility with various GM vehicles, including cars, trucks, and pickups, for both 315 MHz and 433 MHz TPMS systems.
3. O'rnatish va komponentlar
Before using the EL-50448 tool, ensure it is properly prepared.
3.1 Batareyani o'rnatish
The EL-50448 requires a No.9 battery for operation. To install or replace the battery:
- Qurilmaning orqa tomonidagi batareya bo'linmasini toping.
- Bo'lim qopqog'ini oching.
- Insert a fresh No.9 battery, ensuring correct polarity.
- Batareya bo'limi qopqog'ini mahkam yoping.
3.2 Asbob tugadiview
3-rasm: old va orqa views of the EL-50448 tool, highlighting the TX pilot light, low battery indicator, operation button, and No.9 battery compartment.
- TX Pilot Light: Indicates when the tool is transmitting a signal.
- LOW BAT Indicator: Batareyani almashtirish kerak bo'lganda yonadi.
- Ishga tushirish tugmasi: Used to activate the TPMS sensor.
- No.9 Battery Compartment: Houses the required battery.
4. Operating Instructions: TPMS Relearn Procedure
Follow these steps to successfully relearn your vehicle's TPMS sensors using the KINGBOLEN EL-50448 tool. Ensure your vehicle is in TPMS Learn Mode before proceeding.
Figure 4: Visual guide for the 4-step TPMS relearn procedure, showing the sequence for activating sensors on each tire.
- Step 1: Enter TPMS Learn Mode
Turn on the vehicle's ignition. Set the dashboard display to the "Tire pressure learning screen." The horn will beep twice after successful entry into learn mode, and the left front wheel steering lamp yonadi.
- Step 2: Activate Left Front Sensor
Put the antenna of the EL-50448 tool close to the tire sidewall, near the valve stem of the left front wheel. Press the white operation button. The horn will beep twice, indicating that the sensor information has been successfully read. The next wheel's steering lamp yonadi.
- Step 3: Activate Remaining Sensors
Proceed to activate the remaining sensors in the following order, repeating Step 2 for each tire:
- A: Left Front
- B: Right Front
- C: Right Rear
- D: Left Rear
Ensure the horn beeps twice after each sensor activation to confirm successful reading.
- Step 4: Exit TPMS Learn Mode
After successfully reading all four sensors, turn off the ignition. The TPMS relearn procedure is complete. Set the tire pressure to the recommended levels for your vehicle.
5. Xizmat va parvarish
- Saqlash: Foydalanilmayotganda mahsulotni quruq va salqin joyda saqlang.
- Batareya: Replace the No.9 battery when the "LOW BAT" indicator illuminates to ensure optimal performance.
- Tozalash: Qurilmani yumshoq, quruq mato bilan artib oling. Qattiq kimyoviy moddalar yoki abraziv tozalash vositalaridan foydalanishdan saqlaning.
- Ishlov berish: Handle the tool with care. Avoid dropping it or exposing it to extreme temperatures or moisture.
Muhim xavfsizlik eslatmasi: Do not expose this product to fire, as it may cause an explosion. Use the product according to the provided specifications to extend its product life.
6. Muammolarni bartaraf qilish; nosozliklarni TUZATISH
| Muammo | Mumkin sabab | Yechim |
|---|---|---|
| Tool does not activate sensor. |
|
|
| "LOW BAT" indicator is on. | Batareya quvvati past. | Replace the No.9 battery. |
| Horn does not beep after activation. |
|
|
7. Mahsulot spetsifikatsiyalari
| Brend | KINGBOLN |
| Model nomi | 50448-ST |
| Mos keluvchi transport vositalari | GM Series (315 MHz & 433 MHz TPMS) |
| Ishlash chastotasi | 433 MHz (also supports 315 MHz) |
| Quvvat manbai | №9 batareya |
| Material | Plastik |
| Element og'irligi | 141 gramm (taxminan 5 untsiya) |
| Taxminiy o'lchamlar (Uzunligi x Kengligi x Balandligi) | 6.0 x 2.3 x 1.4 inches (Tool dimensions) |
Figure 5: Diagram showing the approximate dimensions of the EL-50448 tool: 6 inches in length, 2.3 inches in width, and 1.4 inches in thickness.
8. Kafolat haqida ma'lumot
Specific warranty details for the KINGBOLEN EL-50448 tool are not provided in this manual. For information regarding warranty coverage, terms, and conditions, please refer to the product packaging, the manufacturer's official website, or contact the retailer from whom the product was purchased.
9. Mijozlarni qo'llab-quvvatlash
If you encounter any issues or have questions regarding the KINGBOLEN EL-50448 TPMS Reset Relearn Tool that are not addressed in this manual, please contact KINGBOLEN customer support through their official website or the contact information provided with your purchase. When contacting support, please have your product model number (EL-50448) and purchase details available.