WAKECAP WC-NODE-A Anchor Node
Qayta ko'rib chiqish tarixi
| Qayta ko'rib chiqish | Sana | Tavsif | Muallif |
| 1.0 | 2025-09-04 | Dastlabki nashr | Rami Nassouh |
Mahsulot tavsifi
The WakeCap Anchor Node (WC-NODE-A) is a fixed wireless mesh router designed for deployment on construction and industrial sites. It enables network coverage extension and improves positioning accuracy of helmet and asset nodes within the 2.4 GHz WakeCap mesh. Anchors are strategically installed based on project size, coverage, and density requirements.
Texnik spetsifikatsiyalar
| Element | Tavsif |
| O'lchamlari | 147 × 131 × 43 mm |
| Dizayn | Rugged plastic enclosure with gasket seal |
| Ulanish | BLE 2.4 GHz SoC, ARM Cortex-M4F, +4 dBm |
| NFC | Embedded NFC Type 2 Tag (ISO 14443-3A) |
| Qurilma identifikatori | Unique 8–10 digit identifier |
| Harakatni sezish | 12-bit ±4g accelerometer |
| Environment Sensing | Onboard temperature/humidity sensor |
| Batareya | 3.6V 19Ah ER34615 Lithium D-cell, replaceable, 10–12 year life (typical) |
| Chiqish | Buzzer |
| Ishlash harorati | kutilmoqda |
| Kirish himoyasi | kutilmoqda |
| Sertifikatlar | kutilmoqda |
Oddiy foydalanish holatlari
- Extending mesh network coverage across large or complex worksites
- Backbone for positioning accuracy of helmet and asset nodes
- Infrastructure-level network reliability
- NFC tap-to-identify
Xizmat ko'rsatish tartib-qoidalari
Preventive Guidelines
- Inspect housing regularly for cracks, water ingress, or corrosion.
- Verify gasket integrity during inspections.
- Avoid exposure to solvents, oils, or high-pressure water jets.
- Confirm NFC readability and dashboard reporting during site audits.
Batareyani almashtirish
Battery Type: 3.6V 19Ah ER34615 Lithium D-cell (non-rechargeable)
Estimated Life: 10–12 years depending on reporting interval
O'zgartirish bosqichlari:
- Move device to a designated safe maintenance area.
- Unscrew the four stainless steel M4 hex screws on the enclosure (torque 1.5 Nm).
- Remove enclosure cap and carefully disconnect PCB JST battery connector.
- Remove depleted D-cell.
- Insert new D-cell in correct polarity orientation.
- Reconnect JST cable to PCB battery connector.
- Ensure gasket is properly seated before resealing the enclosure.
- Tighten M4 screws to 1.5 Nm torque.
- Verify boot-up by tapping the device with NFC to read status.
Notes: Use ESD-safe tools and dispose of lithium batteries properly.
Tozalash bo'yicha ko'rsatmalar
- Use soft cloth with mild soap and water.
- Do not use solvents, alcohol-based cleaners, or abrasive pads.
- Ensure humidity membrane is kept clear of debris.
Dasturiy ta'minotni yangilash
Firmware is not user-updatable. If required, updates are deployed remotely via the mesh.
For update verification, contact WakeCap support.
Muammolarni hal qilish bo'yicha qo'llanma
| Alomat | Mumkin sabab | Yechim |
| Anchor offline | Batareya quvvati tugadi | Replace D-cell (Section 4.2) |
| Out-of-network coverage | Reposition closer to anchors/gateway | |
| Water ingress/hardware fault | Quarantine unit, contact support | |
| Zaif signal | Poor antenna placement | Reinstall higher, away from metal |
| Vaqti-vaqti bilan ishlash | Low battery / unstable link | Check the dashboard, replace battery |
| High interference | Review anchor density, reposition | |
| NFC not reading | Dirt or surface obstruction | Clean NFC area |
| Antennaning shikastlanishi | Inspect, replace if needed |
Xavfsizlik va muvofiqlik
- Ingress Protection: pending
- Compliance: pending
- Battery Safety: Use only ER34615 D-cell. Do not short-circuit, recharge, or expose to fire.
FCC ogohlantirish bayonoti
Ushbu uskuna sinovdan o'tkazildi va FCC qoidalarining 15-qismiga muvofiq, B sinfidagi raqamli qurilma uchun cheklovlarga mos kelishi aniqlandi. Bu chegaralar turar joyni o'rnatishda zararli shovqinlardan oqilona himoya qilish uchun mo'ljallangan. Ushbu uskuna radiochastota energiyasini ishlab chiqaradi, ishlatadi va tarqatishi mumkin va agar ko'rsatmalarga muvofiq o'rnatilmasa va ishlatilmasa, radioaloqa uchun zararli shovqinlarni keltirib chiqarishi mumkin. Biroq, ma'lum bir o'rnatishda shovqin paydo bo'lmasligiga kafolat yo'q. Agar ushbu uskuna radio yoki televizorni qabul qilishda zararli shovqinlarni keltirib chiqarsa, buni uskunani oʻchirish va yoqish orqali aniqlash mumkin boʻlsa, foydalanuvchi quyidagi choralardan biri yoki bir nechtasi bilan shovqinni tuzatishga harakat qilishi tavsiya etiladi:
- Qabul qiluvchi antennaning yo'nalishini o'zgartiring yoki o'zgartiring.
- Uskuna va qabul qilgich orasidagi masofani oshiring.
- Uskunani qabul qilgich ulanganidan farqli zanjirdagi rozetkaga ulang.
- Yordam uchun diler yoki tajribali radio/televidenie bo'yicha mutaxassis bilan maslahatlashing.
Ogohlantirish: Ushbu qurilmaga ishlab chiqaruvchi tomonidan aniq tasdiqlanmagan har qanday o'zgartirish yoki modifikatsiyalar sizning ushbu uskunani ishlatish huquqini bekor qilishi mumkin.
Ushbu qurilma FCC qoidalarining 15-qismiga mos keladi. Ishlash quyidagi ikkita shartga bo'ysunadi: (1) Ushbu qurilma zararli shovqinlarni keltirib chiqarmasligi mumkin va (2) ushbu qurilma qabul qilingan har qanday shovqinni, jumladan, kiruvchi ishlashga olib keladigan shovqinni ham qabul qilishi kerak.
Qurilma umumiy RF ta'sir qilish talablariga javob berish uchun baholangan.
Hujjatlar / manbalar
 | WC-NODE-A Anchor Node |
Ma'lumotnomalar
- Foydalanuvchi uchun qo'llanmamanual.tools